5/15/2023 0 Comments Buy spec mix base stucco![]() ![]() Manufacturers of Western Blended Products (WBP) warrant its products to be of merchantable quality and suitable for the general purpose for which they were intended, when applied in accordance with WBP instructions. Western 1-Kote Gray Concentrate shall be kept indoors or if stored outdoors, shall be adequately covered to keep dry and be stored off the ground.Īpplicable Standards, Specifications and Codes:Ģ018, 2015, 2012 & 2009 International Building Code (IBC).Ģ018, 2015, 2012 & 2009 International Residential Code (IRC). Do not add additional ingredients to Western 1-Kote Gray Concentrate without specific written approval from an authorized manufacturer of Western Blended Products. Do not apply Western 1-Kote Gray Concentrate if conditions are expected to be above or below the specified temperature range within 24 hours of application. Do not apply to surfaces that are contaminated with bond breakers, oils or other matter that may affect the performance of the product. ![]() The recommendations of the finish coat manufacturer shall be followed regarding base coat preparation, bonding, application and curing of their product.ĭo not apply when surface or ambient temperatures are at or below 40☏ / 4.4☌ or above 100☏ / 34☌. Environmental conditions such a heat, wind and low humidity will require additional curing.Ī variety of finishes such as Western Exterior Stucco, standard acrylic paint and Premium Acrylic Finish (PAF) may be applied over Western 1-Kote Gray Concentrate. ![]() The product requires a minimum of forty-eight (48) hours moist curing. The minimum thickness over any substrate, when used in conjunction with the Western 1-Kote Gray Concentrate System, is three-eighths (3/8”) of an inch. Consult product specifications and the IAPMO Evaluation Report #382 for specific details. Specific minimum thickness is required for application over various substrates. The material may be applied by hand or plaster pump. Western 1-Kote Gray Concentrate is applied by approved applicators. Care shall be taken to provide enough time for additional sacks added to the batch, to thoroughly mix. Continuous batching is an acceptable practice. Each sack shall mix for a minimum of five (5) minutes. Western 1-Kote Gray Concentrate is mixed with two hundred pounds (200#), approximately 16 #2 shovels, of ASTM rated plaster sand and approximately 4 gallons of water. The system provides the architect and builder with a cost-effective means of providing a hard wall substrate plus higher insulation characteristics.Īpproximately 72 square feet (3/8”) three-eighths inchĪpproximately 54 square feet (½”) one-half inch The system may be utilized over a variety of substrates affording architects and builders design flexibility. Western 1-Kote Gray Concentrate is packaged in 80 lb / 36.29 kg bags ![]() It is available in a “regular” as well as a “premium” blend. Western 1-Kote Gray Concentrate may also be used over wood or gypsum backing and may be utilized for a scratch and / or brown coat application for a conventional stucco system. The product may be used in conjunction with various foam substrates to create wall assemblies with higher R-values and improved crack and water resistance. Western 1-Kote Gray Concentrate is a fiber reinforced, modified portland cement exterior plaster. ![]()
0 Comments
Leave a Reply. |